OSX Server installation

[Terry Allen <hmag@xxxxxxxxxxxxxx>]

Hi again,
        I will be configuring an OSX Server machine for a local client &
they have had much trouble with slow response of OSX Server - is it
possible to install OSX up to 10.1.5, then install iTools, then install OSX
Server over the top, rerunning the iTools installer afterwards?
        The thing is dog slow (dual 800 Quickilver G4) & took a full 10
minutes to load the netinfo manager. I have given it an IP from my range &
set the gateway to the router on my network. Any ideas on the slow
response? This was a fresh install yesterday.


        Bye for now, Terry Allen
        ___________________________________________________________________
hEARd

Postal Address:
        hEARd
        c/o 128 The Entrance Rd
        The Entrance
        NSW    2261
        Australia

Internet -
        WWW:
        http://heard.com.au or http://www.ozemail.com.au/~hmag
        http://hosting.heard.com.au

Interactive Message Board - http://heard.com.au/wwwboard/

EMAIL: (checked every Thursday & Sunday, sometimes more often)
hmag@xxxxxxxxxxxxxx

-----------------------------------------------
Non profit promotion for new music - since 1994
-----------------------------------------------
Also, check out the Educate site - http://www.educate.net.au


---------                                ---------
Tenon Intersystems' iTools Mailing List
To unsubscribe:  send mailto://itools-
request@xxxxxxxxxxxxxxx
with the subject: unsubscribe
Find searchable mailin list archives at:
http://itools.blackpepper.co.nz