Re: iTools and Post.Office

[Dan Tappin <dan@xxxxxxxxxxxx>]

I always wondered how you did this via the GUI...

Thanks for the tip,

Dan

On Wednesday, April 23, 2003, at 12:33  PM, Eric Yang wrote:

> You can do this:
>
> Click System Preferences, select
> network.
> Show: select Network Port
> Configurations
> Duplicate Built-in Ethernet, then you can
> select "Built-in Ethernet" or 
> "Built-in Ethernet Copy" to
> give them different IP address.
>
> Hope this helps.
>
> regards,
> Eric
>
> On Wednesday, April 23, 2003, at 12:46
> AM, Dtech - Magnus Dagnegård wrote:
> > Hi
> >
> > How do a seperate itools 6.5.7 and
> > Post.Office so the run on different IP?
> > Both on the same machine with only one
> > networkcard.
> >
> > im about to install both of them on a
> > clean OS X jaguar client installation.
> >
> > Regards
> > Magnus
> >
> >
> > ---------
> > Tenon Intersystems' iTools Mailing
> > List
> > To unsubscribe: send mail to
> > itools-request@xxxxxxxxxxxxxxx
> > with the body only containing:
> > unsubscribe
> > Find the searchable mailing list archives
> > at:
> > http://itools.blackpepper.co.nz/                               
> >
> --------------------------------------------------------------------------------------------------

Eric Yang                                                               Senior Software Engineer

Tenon Intersystems                                                                     eyang@xxxxxxxxx

1123 Chapala Street                                                            805-963-6983

> Santa Barbara, CA
> 93101                                            
> http://www.tenon.com
> --------------------------------------------------------------------------------------------------