Re: itools 7 install over itools 6.5.7

[mjack@xxxxxxxxxxxxxxxx (Mark Jack)]

I didn't have any problems installing iTools7 over 6.5.7. That went fine but
my Post.Office application quit working. I have iTools and Post.Office on
the same server. I emailed Tenon support about this problem and Sue told me
to make sure in the System Status page of iTools7 the Enable on Reboot box
is checked for the mail server. Then reboot the server. This worked and
Post.Office started working again. I only have a few websites and
Post.Office is only used for the company email so there's not a lot going on
with my server. All my settings went from 6.5.7 into 7 just fine but I have
seen some issues posted on Tenon's website and on this list. Good luck with
your upgrade.

Regards,
Mark


> From: peter polz <solis@xxxxxxxxxxxxxx>
> Reply-To: itools@xxxxxxxxxxxxxxx
> Date: Wed, 07 May 2003 13:28:39 +0200
> To: <itools@xxxxxxxxxxxxxxx>
> Subject: itools 7 install over itools 6.5.7
> 
> Hello!
> 
> Has anyone a problem by installing itools7 over itools 6.5.7?
> 
> Regards
> 
> Peter
> 
> ---------
> Tenon Intersystems' iTools Mailing List
> To unsubscribe: send mail to
> itools-request@xxxxxxxxxxxxxxx
> with the body only containing:
> unsubscribe
> Find the searchable mailing list archives
> at:
> http://itools.blackpepper.co.nz/                               

---------
Tenon Intersystems' iTools Mailing List
To unsubscribe: send mail to 
itools-request@xxxxxxxxxxxxxxx
with the body only containing: 
unsubscribe
Find the searchable mailing list archives 
at:
http://itools.blackpepper.co.nz/